Approximately 1 year after purchase started developing a crack on the panel beneath the rear window.
02 explorer no door lock.
Turn the ignition back to on.
Push the power door unlock button once to turn on the auto lock feature.
The horn will chirp once if auto lock was deactivated or twice one short and one long chirp if auto lock was activated.
Press the power door lock button once and listen for the horn to beep one time.
Turn the ignition to off.
Press the power door unlock control three times.
No door is opened but the doors refuse to lock and the warning light stays on.
Older versions used a plunger that you could easily test with with your fingers.
The 2002 ford explorer has 7 problems reported for power door lock not working.
Ford explorer since 1995 has been using an in door switch for the door jamb.
Two beeps one short and one long signals that the auto locks have been enabled so if you receive two beeps start the process over again.
The horn will chirp.
Average failure mileage is 95 400 miles.
2002 ford explorer door ajar problem fixed.
The first thing to get keyless entry door factory code you need to locate the passenger fuse panel.
My 02 ford explorer power door locks just up and quit all at the same time.
Re upload from my old channel.
The common problem is that the switch is not closed this will cause your dome lite to be on door ajar light on and will malfunction any aftermarket auto alarm.
Press the unlock control then press the lock control.
On the 2011 2018 ford explorer the passenger fuse panel is located under the instrument panel to the left of the steering column.
One beep confirms the auto locks have been disabled.